Port |
Port Shutdown | Support |
Port Speed | Support auto negotiate,full-1000,full-100,half-100,full-10,half-10 |
Flow Control | support full-duplex IEEE 802.3x, half-duplex back pressure |
Storm Control | Supports rate limit for broadcast, multicast, and DLF packets |
Storm Constrain | Support the detection of broadcast packets,multicast packets or unicast packets on the port, shutdown the port if the rate is over the threshold. |
Port Mirror | Support |
Port Rate Limit | Support port ingress and egress rate limit |
Link Aggregation | Support manual link aggregation Support LACP dynamic link aggregation Supports up to 128 trunk groups with up to 8 members per group Support source MAC, destination MAC, source destination MAC, source IP, destination IP, source destination IP routing strategy |
Port Isolate | Support |
Jumbo Frame | Support up to 12Kbyte packet |
Redundant Port | Support |
The DDM of fiber ports | Support |
MAC |
MAC Table Capacity | 16K |
MAC Table Management | Support |
Forwarding mode | Support IVL forwarding mode |
Static MAC Address | Support |
MAC Address Binding | Support |
MAC Address Filtering | Support |
MAC Learning Control | Control the MAC learning based on port |
VLAN |
Number of VLANs | 4K |
802.1q-based VLAN | Support |
MAC-based VLAN | Support |
IP-based VLAN | Support |
Protocol-based VLAN | Support |
PVLAN | Support |
Voice VLAN | Support |
VLAN Mapping | Support 1:1 mapping |
QinQ | Support basic QinQ Support flexible QinQ |
Reliability |
Spanning Tree Protocol | Support STP/RSTP/MSTP |
Port Loop Detection | Support |
EAPS | Support RFC3619 |
ERPS | Support G.8032/Y.1344 |
LLDP | Support LLDP & LLDP-MED |
UDLD | Fully compatible with CISCO's UDLD protocol |
VLLP(VRRP Layer 2 Loop Protection) | Support, only used with VRRP |
L3 |
ARP | Support static and dynamic ARP |
Static Route | Support static route based on IPv4 and IPv6 |
Routing Table | IPv4: 12K; IPV6: 16K |
VLAN Interface | Support 32 VLAN interfaces |
RIP | Support RIP v1/v2 & IPv6 RIPng |
OSPF | Support OSPFv2 & IPv6 OSPFv3 |
BGP | Support BGP4 & IPv6 BGP4+ |
Policy Route | Support |
VRRP | Support |
Multicast |
Static Multicast MAC Address | Support |
IGMP SNOOPING | Support IGMP SNOOPING v1/v2/v3 Support IGMP Querier Support IGMP SNOOPING Filter |
MLD SNOOPING | Support |
MVR | Support |
GMRP | Support |
PIM-SM | Support |
ACL |
Standard IP-based ACL | Support |
Extended IP based ACL | Support |
MAC IP-based ACL | Support |
MAC ARP-based ACL | Support |
IPv6-based ACL | Support |
ACL Port Filtering | Support |
Time-based ACL | Support |
QoS |
Port Queue Number | 8 |
Port Queue Scheduling Mode | Support WRR,RR,WDRR,SP |
Port-based Classification | Support |
802.1p-based Classification | Support |
DSCP-based Classification | Support |
ACL-based Classification | Support |
QoS Policy | Support packets mapping to queue Support COS or DSCP Remarking Support rate limits of data flow Support data flow statistics Support mirroring of data flow |
DHCP |
DHCPv4 Client | Support |
DHCPv6 Client | Support |
DHCP Snooping | Support |
DHCP Relay | Support |
DHCP Server | Support |
DHCP option 82 | Support |
Management |
CLI Management | Support Console,Telnet and SSH Support multiple TELNET connections based on IPv4 and IPv6 Support multiple SSH connections based on IPv4 and IPv6 Support running configuration rollback Support ZTP (Zero Touch Configuration) |
WEB Management | Support HTTP based on IPv4 and IPv6 Support HTTPS based on IPv4 and IPv6 |
SNMP Management | Support SNMP v1, v2c, v3 Support SNMP TRAP Support lots of standard and private MIBs Support SNMP and TRAP based on IPv4 and IPv6 |
User Management | Support multiple user management |
TACACS+ | Support switch authentication via TACACS+ server remote username and password Support password encryption in PAP and CHAP mode Support TACACS+ server to authorize the switch’s commands Support TACACS+ based on IPv4 and IPv6 |
Log Management | Support local log management Support SYSLOG based on IPv4 and IPv6 |
RMON | Support RMON 1, 2, 3 and 9 groups |
Cluster Management | Support NDP Support NTDP Support manual and automatic joining of cluster groups Support cluster unified management |
OAM | Support 802.3ah Support 802.1ag |
Configuration File | Support uploading and downloading configuration file Support TFTP transmission based IPv4 and IPv6 Support SFTP transmission based IPv4 and IPv6 Support SFTP Client and SFTP Server |
Upgrade software | Support uploading and downloading upgrade software Support TFTP transmission based IPv4 and IPv6 Support SFTP transmission based IPv4 and IPv6 Support SFTP Client and SFTP Server |
Clock Management | Support local clock management Support SNTP based IPv4 and IPv6 |
PoE Management | Per port PoE function enable/disable Total PoE power budget control Per PoE port power limitation PD classification detection PD alive check
Scheduled power rebooting PoE schedule
PoE Port Status monitoring PoE port power feeding priority |
Security |
Switch Management Security | Support enabling and disabling TELNET、SSH、HTTP、HTTPS and SNMP services Support TELNET、SSH、HTTP、HTTPS and SNMP services to bind to standard IP ACLs Support for limiting the number of TELNET and SSH connections |
CPU Protection | The switch's own security protection prevents large data streams from attacking the switch itself. |
AAA | Support 802.1x Support RADIUS Supports authentication, authorization, and accounting through RADIUS server Support port-based and MAC-based 802.1x Support 802.1x guest VLAN |
IP MAC Binding | Support static configuration of IP, MAC and port binding |
DHCP SNOOPING | Support dynamic ARP binding to prevent ARP spoofing Support dynamic IP, MAC and port binding Support fixed port to connect to DHCP server to prevent private connection to DHCP server |
Prevent ARP Spoofing | Support manually configuring MAC ARP-based ACL rules to prevent ARP spoofing. Support the DHCP SNOOPING function. During the process of obtaining an IP address by DHCP,the switch dynamically binds ARP to the port to prevent ARP spoofing. |
IPv6 |
IPv4/IPv6 Dual Protocol Stack | Support |
IPv6 Address | Support manual address configuration, stateless address auto-configuration and stateful address configuration obtained through DHCPv6 client |
IPv6 Neighbor Discovery | Support |
ICMPv6 | Support |
IPv6 Path MTU Discovery | Support |
Debugging |
PING | Support |
PING6 | Support |
TRACEROUTE | Support |
TELNET Client | Support TELNET client based IPv4 and IPv6 |
SSH Client | Support SSH client based IPv4 and IPv6 |
TWAMP | Support TWAMP server and session-reflector |
